Please select the proper Answer

1. In order to step through the Windows 9X boot process, you press_____________ while the system is
   starting.

   1.   ?    F3
   2.   ?    F4
   3.   ?    F5
   4.   ?    F8

2. What is correct sequence that occurs when Windows 2000 starts

   1.   ?    NTLDR
      Boot.ini
      NTDETECT.COM
   2.   ?    NTLDR
      NTDETECT.COM
      NTLDR
   3.   ?    NTDETECT.COM
      Boot.ini
      NTLDR
   4.   ?    Boot.ini
      NTLDR
      NTDETECT.COM

3. What utility do you use to check the IP configuration on a Windows 95 / 98 workstation?

   1.   ?    winipcfg
   2.   ?    netstat
   3.   ?    ping
   4.   ?    ipconfig

4. You are installing a new Windows 98 system, and the installation routine freezes. What should you do?

   1.   ?    Shut off the system, and re start, the installation routine will know where it left off.
   2.   ?    Shut it off, and start over, by formating the hard drive.
      
   3.   ?    Replace the Installation CD and start over.
   4.   ?    Run the Recovery console from the Installation CD, and start the install over again.

5. What is first step to install Widnows 98 on a PC that does not have any OS at all.

   1.   ?    Format the C drive
   2.   ?    FDISK
   3.   ?    Install the OS from the CD
   4.   ?    Format C with A

6. Which of the following commands does not belong in the autoexec.bat file

   1.   ?    Echo
   2.   ?    Files
   3.   ?    Pause
   4.   ?    LH

7. A real mode driver is one that ___________________________________

   1.   ?    Indirectly accesses hardware
   2.   ?    Accesses software directly
   3.   ?    Accesses hardware directly
   4.   ?    A Windows 3.1 driver.

8. What are the main categories in the Windows 9X installation?

   1.   ?    Disk Preparation
      Copying Operating System
      FAT preparation
      Finishing Installation
      Preparing to Start First Time
   2.   ?    Gathering Information
      Copying Files
      Finishing Installation
   3.   ?    Disk Preparation
      Copying Files
      Copying Operating System
      Finishing Installation
   4.   ?    Disk Format & Preparation
      Copy Operating System & Files
      Closing Installation
      Preparing to run Windows for the first time.

9. When formatting the hard drive, which of the below tasks is not performed.

   1.   ?    Scanning the surface to find bad spots.
   2.   ?    Laying magnetic tracks in concentric circles.
   3.   ?    Tracks are split into 512 bytes called cylinders.
   4.   ?    High Level formats create a file allocation table.

10. When a drive is partioned using FDISK, what is the name of the first partition that is created.

    1.   ?    Main
    2.   ?    Primary
    3.   ?    Active
    4.   ?    Extended

11. In Windows 9X, the command used to edit the registry is____

    1.   ?    Sys Edit
    2.   ?    RegEdit
    3.   ?    Autoexec.bat
    4.   ?    Automenu

12. Which of the following would have the greatest impact on a browser's performance

    1.   ?    Client's RAM
    2.   ?    Server's RAM
    3.   ?    Client's Processor
    4.   ?    Server's Internet Connection

13. Which of the following is not a valid permission on a Windows 2000 system

    1.   ?    Read
    2.   ?    Attribute
    3.   ?    Write
    4.   ?    Execute

14. What is the Ping utility used for?

    1.   ?    Used to test a browser.
    2.   ?    Used to test all of the network connections
    3.   ?    Used to test the connection between two computers.
    4.   ?    There is no such utility.

15. While running Win NT, you want to convert your FAT16 partition to NTFS. What command do you use to do this conversion.

    1.   ?    FDISK /MBE /C
    2.   ?    CONVERT c:/FS>NTFS
    3.   ?    CONVERT C:/NTFS
    4.   ?    CONVERT C: /FAT16>NTFS

16. In Windows XP, how would you get to a command prompt?

    1.   ?    Start, Programs, Accessories, MSDOS
    2.   ?    Start, Programs, Accessories, Command
    3.   ?    Right Click on the desk top, Properties, and select the command button.
    4.   ?    Start, Run, enter cmd, and press enter.

17. Which ones of the below list are operating systems.

    1. MSDOS
    2. Windows 3.1 for Workgroups
    3. Windows 95A
    4. Windows XP
    Check Answer(s)

18. Which of the following are features of Windows 95 SR2 over Windows 3.1

    1. Long File Names
    2. FAT32
    3. NTFS
    4. GUI
    Check Answer(s)

19. In Windows XP Pro, in order for RIS to work, the following must apply:

    1. The RIS folder must reside on a different disk
    2. The RIS folder must reside on a separate partition from the OS
    3. The RIS must use NTFS
    4. The RIS must use FAT32
    Check Answer(s)

20. What is the minimum RAM requirement for a Windows XP Installation

    1. 32 MB
    2. 64 MB
    3. 128 MB
    4. 256 MB
    Check Answer(s)

21. Windows 2000 can support the following file systems. (Choose all that apply)

    1. FAT16
    2. FAT32
    3. HPFS
    4. CDFS
    5. NTFS
    Check Answer(s)

22. Which Operating Systems can upgraded to Windows 2000. (Choose all that apply)

    1. Windows 3.X
    2. OS/2
    3. Unix
    4. Windows 9X
    5. Windows NT4.0
    6. MSDOS
    Check Answer(s)

23. You are going to upgrade your customer's system from Windows 98SE to Windows 2000 Pro. What is the first thing that you should do?

    1. Put the Install/Upgrade Cd in the Drive, and begin the installation.
    2. Backup the MBR
    3. Backup all programs and data
    4. Make sure that all components are on the HCL.
    Check Answer(s)

24. In General, what is the order for a system that is booting up.

    1. GUI, MBR, BIOS, CMOS
    2. Post, BIOS, Boot Sector, GUI
    3. Boot Sector, BIOS, OS
    4. OS, Post, Bios, GUI
    Check Answer(s)

25. How do you start the Disk Defragmentation utility in Windows 98SE. (Choose all that apply)

    1. Start, Programs, Disk Tools, Defragment
    2. Start, Programs, Accessories, System Tools, Disk Defragmenter.
    3. Start, Programs, Device Manager.
    4. Start, Run, DD
    Check Answer(s)

26. You want to make a change in your Autoexec.bat file. How do you do that?

    1.   ?    RegEdit
    2.   ?    Sysedit
    3.   ?    Manager's Console
    4.   ?    GNU Editor

27. What does the DOS command XCopy /S do?

    1.   ?    There is no such command, the command is Copy
    2.   ?    It will copy all files, directories, and sub-directories, of what is specified.
    3.   ?    It will copy all hidden and system files as well as all others.
    4.   ?    XCopy will copy those files specified, and save an additional copy.

28. In MSDOS, which file loads device drivers?

    1.   ?    Autoexec.bat
    2.   ?    IO.Sys
    3.   ?    Config.sys
    4.   ?    MSDOS.sys

29. While in Device manager, you notice that your modem is listed with a yellow circle, with a black exclamation point. What does this mean.

    1.   ?    Nothing, all devices when working properly have this.
    2.   ?    The Device driver has not been loaded.
    3.   ?    The device has been removed.
    4.   ?    The device is not working properly.

30. To transfer email, what protocol is used.

    1.   ?    TCP/IP
    2.   ?    HTTP
    3.   ?    DNS
    4.   ?    SMTP

31. To enter the boot logging mode when starting Windows 2000, press

    1.   ?    F1
    2.   ?    Alt F8
    3.   ?    Ctrl F8
    4.   ?    F8

32. When performing a backup of a win 2000 workstation, and you want to include the registry, you should.

    1.   ?    There must be two different backups made. One for the system, and one for the registry.
    2.   ?    Copy or Export the registry file to a text file in Notepad, and then backup the system.
    3.   ?    Choose backup from the utilities, and this will backup the registry also.
    4.   ?    Use the backup utilitty and select System State.

33. You want to access a large University's web site. You know the domain name is the same as the university, what extension should you use?

    1.   ?    .Com
    2.   ?    .Edu
    3.   ?    .Gov
    4.   ?    .Sch

34. What path can be used to connect to a Networked Printer in Windows 2000 Pro?

    1.   ?    Start>Settings>Control Panel>System>
    2.   ?    Start>Settings>Control Panel>Add/Remove Hardware
    3.   ?    Start>Settings>Printers
    4.   ?    Start>Printers

35. What utility would you use from an NT workstation command prompt to test a connection between your PC and another PC with several routers and computers in between?

    1.   ?    Ping
    2.   ?    Netstat
    3.   ?    Winipcfg
    4.   ?    Tracert

36. In Windows 9X, how can you get a printout of the system configuration from a command line?

    1.   ?    Type: PRN /CFG and press enter
    2.   ?    Type: CFG /PRN and press enter
    3.   ?    Type: WINIPCFG /PRN and press enter
    4.   ?    Type MSDN, press the print screen key.

37. In Windows 9X, pressing the Shift F8 keys does what?

    1.   ?    Refresh the Desktop
    2.   ?    Sends the user to BIOS
    3.   ?    Brings up the DOS boot menu
    4.   ?    Goes into System manager

38. Your customer calls and states that their Win 98SE computer on a small peer to peer network, must always have a drive mapped at logon. Can you prevent to always have to map a network drive?

    1.   ?    No, this cannot be done.
    2.   ?    Yes, simply check, "Reconnect at Logon" when the logon is established.
    3.   ?    Yes but only on the drives with the NTFS format.
    4.   ?    Yes, only by upgrading to Windows XP

39. In Win 98SE, what key is pressed to activate the interactive startup menu, during the boot process.

    1.   ?    The Del key
    2.   ?    The End Key
    3.   ?    The F2 Key
    4.   ?    The Home Key

40. What is the smallest unit of measure a Win 98SE hard drive can use?

    1.   ?    Platter
    2.   ?    Cylinder
    3.   ?    Sector
    4.   ?    Cluster